lsi megaraid storage manager in safe mode

Hopefully this will answer many of the questions we get. One can see in the screenshot above that the Slot: 2, SSD (SAS) device, our test Samsung SM1625 SSD no longer has the blue arrow and is no longer labeled a “Foreign” device. It may take a second or two but you should get a confirmation window. Click the checkbox and say yes assuming you do want to clear the configuration. This will bring up a confirmation prompt. LSI MegaRAID Foreign Configuration – Import or Clear In our use case we are just trying to access the SAS SSD as a single device so we will select Clear: Remove logical configuration from all foreign drives. If you were bringing over two drives in RAID 1, and wanted to keep the RAID 1 array intact, using Import would be a good option. LSI MegaRAID Scan Foreign ConfigurationĪt this point, MSM will scan drives on the controller and say how many foreign drives it found. Then select Go To -> Controller -> Scan Foreign Configuration as shown below. Somewhat counter-intuitively (when managing one newly added foreign drive) one needs to click on the controller not the drive in MSM. The solution to our use case is to reset the drive’s configuration. The Solution to Fix a Drive Labeled as Foreign by a LSI/ Avago SAS controller If, however, I cross-flash the chip to the IT mode firmware using either the Supermicro supplied version or the Broadcom 9300-8i the flash completes successfully, MegaRAID is able to see the disks and the enclosure, but the drives are not being passed through to Windows Disk Management/Storage Spaces. Like our use case, we are going to clear the previous configuration (RAID 0 from the Samsung SM1625 200GB SSD RAID 0 testing) and make it usable as a data drive again. Other drives do not have the (Foreign) label nor the blue arrow on the drive. Here one can see our Samsung SM1625 SAS SSD is labeled as a foreign drive in MegaRAID Storage Manager. We recreated this in our lab using an onboard LSI SAS 3008 HBA. I was reading that LSI to LSI is supposed to work. When I try, I can see the drive in the LSI utility, but it doesn’t immediately register for me to pass-through like others. I’m trying to migrate my old VM store SSD to a ZoL on server. “STH I found info on my LSI 9271-8i and LSI 9300-8i here. The Foreign Drive ProblemĪlthough this question has been asked many times to date, here is the latest question: That is causing the drive to be labeled as foreign. What is happening is that the drive was previously inserted on another machine and a LSI/ Avago configuration was previously written on it. For years now this question has come up in various forms so today it is time to show the easy fix. Truenas auto trim.Here is one from the mailbag about how to fix a drive labeled as foreign by a LSI/ Avago SAS controller when it is inserted into a system.

Lsi megaraid storage manager in safe mode